D.P. Tool & Machine, Inc. has extreme Wire EDM capabilities with the ability to cut up to 18" thick material.  Our Wire EDM cuts quickly and provides a superior surface finish with dimensional accuracy within .0001" and a minimal .005" corner radius.  Check out the Machine Specifications and the Picture Gallery sample parts. 

Our Wire EDM is a cost effective way to manufacture parts that require tight tolerances with complex geometry!

Wire EDM Models: 

• Mitsubishi FA20S Wire EDM
• Japax Bridgeport ( 8" x 14" x 5.8" Thick)

FA-20S Wire EDM

FA-20S Wire EDM Specifications
General Information	Inch	Metric
Max. Submerged Workpiece Dimensions	41.3 x 31.5 x 11.6	1050 x 800 x 295
Max. Submerged Workpiece Weight	3300 lb.	1500 kg
Table Dimensions	30.7 x 24.8	780 x 630
Machining Range X-Y	19.7 x 13.8	500 x 350
Max. Z-Axis Height	18	300
U-V Axis Travel (from center)	±3.0	±75
Taper Angle @ Thickness	15 deg.@ 10.5	15 deg.@ 265
Wide Angle Taper (Optional Guides Required)	45 deg. @ 2.4" (No AT Possible)
Minimum Drive Unit / Resolution	0.00001 / 2 millionths	0.0001 / 0.05µm
User Program Storage [Hard Disk Size]	1 G [20 GB]
Table Rapid Feed Speed	51.2 "/min	1300 mm/min
Wire Diameter Possible	0.004~0.012	0.1~0.3
Minimum Start Hole Diameter	0.02	0.5
Max. Wire Spool size STD [optional]	22 lb. [44 lb.]	10 kg [20 kg]
Filters / Type	2 / Paper	2 / Paper
Filter Tank Capacity	195 gal	740 L
Machine System Dimensions	101.5 x 109.0	2580 x 2770
Machine Installed Height	84.6	2150
Machine System Weight	9116 lb	4135 kg
Power Requirements [KVA]	200-230V [13.5] Built in AVR
Compressed Air Requirements	2.7 cu.ft./min. @ 71~100 psi